30 Amp Pulse Width Modulated Charge Controller
Availability: in stock
30 Amp PWM Charge Controller for 12 or 24 Volt Systems.
The 30 A PWM charge controller is the economical choice for your low voltage solar panels.
◆Microcontroller digital accuracy
◆PWM charge mode & State of Charge(SOC)
◆Fully automatic operation & Electronic protections
◆Detects day and night using the PV array, timer setting
◆Double digital LED display, numbers equal to timer setting
◆Temperature compensation, with internal temperature sensor
◆Big terminals, big distance between terminals
Automatically detects 12 Volt or 24 Volt battery banks, 30 Amp Maximum (for PV and load)
Equalization voltage: 14.8 Volt
High voltage disconnect(HVD): 14.4Volt
Float voltage: 13.6Volt
Low voltage disconnect(LVD) 11.1Volt
Low voltage reconnect(LVR): 12.6Volt
Self-consumption: 6mA maximum
Temperature compensation: -30mV/℃/12V
Terminals: for wire sizes to 6mm2
Temperature: -35℃ to +55℃
Solar Panel LED:
Green ON when solar is charging Battery.
Green blinks when the syetem in an over voltage condition.
Green is ON when battery level is good.
Green Slowly flashes when battery level is full.
Yellow light is ON when battery level is low.
RED ON when the load cuts off.
This controller has Light and Timer control Function
This function, which is common to most charge controllers, allows you to run a light. We can program it to come on when it gets dark and will stay on for a specified number of hours.
Short and Open Circuit protection
Fail Safe and cannot be damaged by accidental wiring mistakes
Advanced design with simple plug and play technology. No need for complicated adjustments